LCC / Mineral Facade Putty with Light Filler

Suitable for Leveling All Types of Mineral Surfaces

• Can be used for creating reliefs and various decorative elements, filling deep recesses, and damage caused by erosion.
• Thickness of a single layer can be up to 50 mm.
• Once cured, the material sands well, is resistant to cracking, and can be painted with all types of mineral surface paints.
• Lightweight, it exerts minimal load on façade elements.
• Suitable for both outdoor and indoor work, as well as in areas with increased humidity.
• Available in two fractions: 0.5 mm and 1 mm.

Application:

• The substrate must be dry, clean, and stable. The temperature of the substrate and surrounding environment during treatment and curing should be between +5°C and +25°C.
• Clean the substrate of dust, oils, residues of old paint, and layers of surface material that are starting to detach.
• Prime the surface with SAKRET UG primer by diluting it with water in a ratio of 1:3, or, in the case of loose surfaces, with SAKRET TGW primer.
• Mix SAKRET LCC-1 or SAKRET LCC-0.5 filler in a container with cold, clean water until a homogeneous mass without lumps is formed.
• Allow the mixed mass to rest for 3 minutes and stir again.
• Apply the resulting filler mass to the surface using a metal spatula.
• Do not dilute material that has begun to set with water!
• The treated surface can be sanded after 12 to 24 hours, depending on the curing conditions.
• Protect the treated surface from frost, direct sunlight, atmospheric precipitation, and drafts during the curing of the filler!

Consumption:
From 15 kg of dry mixture, approximately 13.5 liters of ready-made filler can be obtained.
The minimum layer thickness for SAKRET LCC-1 is 1 mm, and for SAKRET LCC-0.5 is 0.5 mm.