NSP / Fast Setting Self-Leveling Compound for Floors

Details:

• Type: Fast-setting.
• Application: For floor installation (3 - 20 mm).
• Self-leveling: Suitable for leveling full and partial horizontal surfaces.
• Base: On concrete substrates.
• Heating: Usable on heated substrates.
• Composition: Cement-based.
• Usage: Before applying a finishing layer.

Application:

• Surface Preparation:

  • Ensure the substrate is dry and solid, with all cracks and voids filled.
  • Clean the substrate from weak or removable layers.
  • For absorbent surfaces, prime with SAKRET UG (diluted 1:2).
  • Very dry and absorbent surfaces should be primed twice.
  • This material can be used on concrete and other mineral substrates.
  • DO NOT USE SAKRET NSP on gypsum or anhydrite substrates!
  • When using SAKRET NSP on heated floors, turn off heating 5 days prior and do not turn it back on for 28 days after installation.

• Mixing:

  • Mix SAKRET NSP in a clean container with cold water until a homogeneous mixture without lumps is achieved.
  • It is recommended to use a mixer with 600 RPM.
  • After a maturation time of approximately 3 minutes, remix.
  • Do not dilute material that has started to set with water; instead, remix with a mixer.

• Application:

  • Apply the mixture to the surface (layer thickness >3 mm) and level with a spike roller.
  • Deformation joints in the floor should not be filled with the leveling compound.
  • When leveling the substrate, a cushioning material should be incorporated around the perimeter.
  • When using this material for large-scale floor leveling, it is essential to adhere to the intervals for floor deformation joints.

Important Notes:

• Technical data applies at +20°C temperature and 50% relative humidity. Lower temperatures increase, while higher temperatures decrease the specified values.
• Protect the leveling compound during the curing phase from sun, drafts, frost, and excessively high temperatures (>25°C).
• Cured material can only be removed mechanically.
• Contains cement; reacts alkaline. Protect skin and eyes, and follow technical instructions. If material gets into eyes, rinse with plenty of water and seek medical attention if necessary.
• Protect the packaging from weather effects, store on wooden pallets in a cool, dry place, and immediately cover opened packaging.