FS / Floor Leveling Compound

Details:

• For leveling floors before final finishes
• Can be used as a final layer for low-stressed surfaces
• Suitable for leveling full horizontal planes
• For correcting defects in concrete substrates
• For filling horizontal inter-panel joints
• Frost and moisture resistant
• Plastic during leveling; mechanically levelable
• Suitable for heated floors
• Accelerated initial curing time
• Cement-based
• Layer thickness: 10 - 60 mm
• Tiles can be applied directly on surfaces leveled with SAKRET FS without additional leveling. If a thin-layer covering is applied on SAKRET FS, the surface must be additionally leveled with SAKRET NSP.

Application:

Surface Preparation:

• The substrate must be dry and solid, with all cracks and voids filled.
• Clean the substrate of less stable and/or removable layers.
• Absorbent surfaces should be primed with SAKRET UG primer (diluted 1:2).
• Dry and especially absorbent surfaces should be primed twice!
• The compound can be used on concrete and other mineral material substrates.
• Do not use SAKRET FS on gypsum or anhydrite substrates!
• When using SAKRET FS on heated floors, the heating must be turned off 5 days prior and should not be turned on for 28 days after installation of the material!

Usage:

• Mix SAKRET FS in a clean container with cold water until a homogeneous mass without lumps is achieved.
• It is recommended to use a mixer at 600 revolutions per minute.
• After the maturation time of approximately 3 minutes, remix.
• Do not dilute the binding material with water but remix it with a mixer.
• Pour the compound onto the surface (layer thickness >10 mm) and level it.
• Floor deformation joints must not be filled with the leveling compound.
• When leveling substrates, cushioning material should be incorporated around the perimeter.
• When using the material for large-volume floor leveling, it is mandatory to observe the intervals of floor deformation joints.
• Hardened mass can only be cleaned mechanically.

Instructions:

• Technical data refer to a temperature of +20°C and a relative humidity of 50%. Lower temperatures increase, and higher temperatures decrease the specified values.
• Protect the leveling compound during the curing phase from sunlight, drafts, frost, and excessively high temperatures (>25°C).
• Contains cement, reacts alkaline.
• Protect skin and eyes; follow technical instructions. If the compound gets into the eyes, rinse with plenty of water and seek medical attention if necessary.
• Protect the packaging from weather effects; store on wooden pallets in a cool, dry place; cover opened packaging immediately.