FK / Tile Adhesive

Details:

• Cement-based
• Suitable for application in thin and medium layers
• For ceramic and stoneware tiles (not exceeding 35x35 cm)
• For bonding to concrete or other stable mineral surfaces
• Available in gray or white

Preparation:

• The substrate must be dry and solid; all cracks and voids should be filled.
• Clean the substrate of any loose or easily removable layers.
• Treat particularly dense and/or smooth surfaces with abrasive material.
• Prime the surface with SAKRET UG primer (diluted at a ratio of 1:3).
• For very smooth concrete surfaces, use SAKRET QG primer.
• Mix SAKRET FK in a clean container with cold water until a homogeneous, lump-free mixture is achieved.
• It is recommended to use a mixer at 600 RPM.
• After a resting time of approximately 3 minutes, remix the adhesive.
• Cover an area with adhesive that can be tiled within about 15 minutes.
• Do not fill expansion joints with tile adhesive.
• Avoid tiling in direct sunlight, drafts, or on damp surfaces.
• The technical data refers to a temperature of +20°C and 50% relative humidity. Lower temperatures increase and higher temperatures decrease the specified values.
• Protect the adhesive during the curing phase from sunlight, drafts, frost, and excessively high temperatures (>25°C).
• Cured tile adhesive can only be removed mechanically.
• Contains cement; reacts alkaline.
• Protect skin and eyes, and follow technical instructions. If the mixture comes into contact with eyes, rinse with plenty of water and seek medical attention if necessary.
• Protect the packaging from weather conditions, store on wooden pallets in a cool, dry place, and immediately cover any opened packaging.