RS / Fast-Setting Repair Mortar for Concrete Products

Application:

• For repairing defects in concrete products (such as grooves, recesses, unfilled spaces in formwork, etc.).
• For repairing defects that have occurred during use.
• Suitable for both newly laid and existing concrete.
• Fast-setting.
• Water and frost resistant.
• High mechanical strength.
• Not suitable for concrete with a compressive strength lower than 15 N/mm².

Preparation:

• The surface must be clean and mechanically strong.
• Clean the surface from less stable and/or separating layers.
• Prior to treatment, the surface should be primed with universal primer SAKRET UG (diluted 1:3).
• The repair compound can be applied to the surface without waiting for the primer to dry.
• Add approximately 290 ml of water to 1 kg of repair compound and mix thoroughly.
• Apply the prepared mixture to the surface with a trowel or metal float and level it out.

Important:

• Technical data refer to a temperature of +20°C and 50% relative humidity.
• During the curing phase, protect from sunlight, drafts, and excessively high temperatures (>30°C).
• Protect fresh mortar from rain and rapid drying. Once the mortar starts to set, do not add water!
• Immediately after mixing the mortar, wash containers and tools with water. Cured mortar can only be cleaned mechanically.
• Contains cement and reacts alkaline. Protect skin and eyes, and follow the technical instructions. If mortar comes into contact with the eyes, rinse with plenty of water and seek medical attention if necessary.
• Protect packaging from weather effects; store on wooden pallets in a cool and dry place, and immediately cover opened packaging.